Sol: Input ports repair

Using a Phillips head screwdriver, carefully remove the 2 screws at the front and back of the lamp's body.

Screws are small and light, so make sure to place them in a safe spot to avoid losing them.

Carefully separate the two parts of the lamp by pulling the white shade, and the black base in opposite directions.

After removing the shade, the main electronic cicuit board (PCB) will be exposed.

Using a Phillips screwdriver, remove the 6 screws around the entire perimeter of the board.

Once all 6 screws have been removed, carefully separate the white plastic frame from the black base of the lamp.

Make sure to pull gently, as there are cables connecting the two parts together.

Underneath the PCB, there are 3 sets of cables. 

Gently pull the cables away from the circuit board and disconnect everything. 

Remove the PCB from the lamp, and take the plastic frame that sits around it off.

Using your hands, pull apart the two halves of the bottom case.  

Using a Phillips head screwdriver, remove the 2 screws holding the ports' board. Replace with the new one.

Make sure to dispose the damaged board as e-waste

To reassemble the base, align all the components, including the swiveling handle.

Put the two halves together, ensuring all components and cables remain in the correct place.

Press lightly until they stick.

Using both hands, press hard until they snap into place.

Reconnect the battery cables to the PCB connector. Make sure to use the connector next to the round edge of the frame.

Align the top frame and the base. 

The two parts will only assemble correctly in one orientation, so look for the keyhole-shaped features and align them on top of each other.

Align and lightly press down the PCB and frame until it sits in place.

Reverse each step from steps 4 to 1 to reassemble the lamp.