Skip to content

Ports cover replacement


Required tools

  • Screwdriver - Torx 5

  • Screwdriver - Torx 6

  • Knife

  • DC Port Cover

  • USB Port Cover


Step 1

Unscrew lamp casing

Using a Torx 6 screwdriver, carefully remove the 3 screws at the bottom of the case.

Screws are small and light, so make sure to place them in a safe spot to avoid losing them.


Step 2

Open the plastic casing

Carefully separate the two parts of the plastic casing. Make sure not to pull too fast as there is a battery cable still keeping the two parts together.


Step 3

Pull battery out from bottom casing

Gently pull out the battery.

If the battery is locked very tight, pull firmly but with care not to damage the cables.

Avoid using sharp tools such as pliers, which may damage or break the cables to the battery. This is a safety hazard!

DO NOT use sharp edge tools to pull battery out.


Step 4

Disconnect battery from electronics board

In the case your battery is soldered instead of having a connector, you may continue on the next step. Being careful NOT to bridge the two ends of the battery with any metallic item.

If your lamp's battery has a connector, this will have 2 halves, 1 soldered to the board, and 1 attached to the battery cables. Using your fingers, gently pull the battery connector half. (Pulling the entire connector, might lead to breaking the solder

You might find silicon glue around the connector; this is not hard to remove by simply pulling the connector away.


Step 5

Unscrew electronics board.

Using a Torx screwdriver, remove the 2 screws from the board. One or both might be hidden behind the black foam piece.

Screws are small and light, so make sure to place them in a safe spot to avoid losing them.


Step 6

Lift up electronics board

Using a knife or a flat head screwdriver, carefully pry up the electronics board, once you are able to see the edges of the board you can use your fingers to lift and rotate it to expose the underside.

Be careful not to pull too far/hard as the board is soldered to 2 more wires underneath.


Step 7

Install the new plastic cover.

Using pliers or your fingers, remove from the bottom of the case any remaining material from the damaged cover.

Insert the narrow part of the new cover in the hole of the casing top. Push it in, and with the help of pliers, pull the narrow portion of the cover until it snaps in place and is well secured.

Try lightly pulling the cover to make sure it is correctly installed.



Step 8

Reassemble the lamp

Following the steps 5-1 in reverse order, reassemble the lamp.